PIONEER 1000 DOOR-SKIN MARKING TEMPLATE — V8
Free dealer download from Honda of Lafayette
hondaoflafayette.com

PURPOSE AND FIT
This workshop-developed template helps transfer a door-skin cut outline when
installing a full-door cab kit, including onto camo skins without a visible
factory line. It locates against the colored skin's top and adjacent side edges
while that skin remains installed on the stock door.

Honda of Lafayette accepted the V7 physical fit on its tested setup. V8 retains
that geometry and changes the recessed website lettering and version mark.
The new V8 lettering has not yet been evaluated on a physical print.

Compatibility has not been established for specific vehicle model years,
seating configurations, or cab-kit manufacturers and part numbers. Compare
the template with your actual skin and the kit's required cut outline.

CHOOSE LEFT OR RIGHT
LEFT and RIGHT describe the side stop when looking at the installed template
from the front, with the website facing you and the long arms pointing up.
They are not confirmed driver/passenger-side designations. Choose the file
whose side stop meets the adjacent colored skin edge. Each STL prints as one
connected piece, with no coupons or loose assembly parts.

CURRENT DIMENSIONS — MILLIMETERS
  Top skin edge to opening: 46
  Side skin edge to opening: 16
  Both top lips: 8 below their local seats
  Side lip: 6 below its local seat
  Opening: approximately 166.527 x 90.632, with 22.000 corner radii
  Frame base: 1.6
  STL bounding box: approximately 194.653 x 148.758 x 9.6

The website is recessed: 7 mm bold lettering, an additional 0.5 mm between
characters, and a 0.6 mm engraving depth. These are fixed-position templates.

PRINTING
The supplied orientation is FRONT FACE DOWN: website toward the build plate,
rearward lips pointing UP. Keep millimeters and 100% scale; supports OFF.

Use a 0.4 mm nozzle and 0.20 mm layer profile with the profile for your actual
printer and filament. The development printer is a Bambu Lab P1S. Check the
sliced preview and build-plate placement. Use the supplied opposite-hand STL
instead of mirroring the branded model.

MARKING THE SKIN
1. Flip the print into its working position: website outward, long arms UP,
   lips toward the door. Keep the skin installed on the stock door.
2. Seat on the COLORED skin edges, not the black backing. Settle DOWN and RIGHT
   for LEFT, or DOWN and LEFT for RIGHT, so the top and side stops make contact.
3. First compare the entire inside tracing edge with a factory-lined red or
   green skin, including every corner. Lift and reseat to check repeatability.
4. Hold or tape the frame in position while marking; the edge stops locate
   the template but do not clamp it. Once the outline agrees with the required
   cut, use the inside edge to mark the camo skin. Follow the cab kit's
   instructions for cutting and installation.

DOWNLOAD CONTENTS
  One current V8 LEFT STL
  One current V8 RIGHT STL
  This README
  A preview image
  A version/file manifest

This download contains the current printable templates and their instructions.
Development scans, source history and previous template versions are omitted.